89Sabers K4V2 Kenobi Removable Chassis
89Sabers K4V2 Kenobi Removable Chassis
89Sabers K4V2 Kenobi Removable Chassis
89Sabers K4V2 Kenobi Removable Chassis
89Sabers K4 Kenobi Removable Chassis - Saberbay
89Sabers K4V2 Kenobi Removable Chassis
89Sabers K4V2 Kenobi Removable Chassis
89Sabers K4V2 Kenobi Removable Chassis
89Sabers K4V2 Kenobi Removable Chassis

89Sabers K4V2 Kenobi Removable Chassis

Regular price $30.00 Save $-30.00
/
Shipping calculated at checkout.

BUYERS NOTE THIS IS NOT A FULLY INSTALLED SABER, this is a DIY kit for installing your own electronics.

3D printed removable chassis for the 89Sabers K4V2 Kenobi hilt.

This chassis is printed in two pieces, three if including the low profile NPXL V3 shortpin holder for the emitter.

Low profile NPXL V3 holder for the emitter is 5mm in height and is made for the short pin version only.

Thin neck adapter part holds the blade side PCB(resistor not needed here). This part needs to press fit all the way up into the brass section of the thin neck.

Main chassis body holds the following parts:

-Soundboard(CFX, Proffie, GoldenHarvestV3)

-Removable KeepPower 18650 battery(high amp, button top required for neopixel)

-Removable battery contacts(provided with the chassis)

-OLED screen(optional, sold here at Saberbay)

-High amp killswitch(optional, but recommended, sold here at Saberbay)

-Switch PCB parts included with the hilt kit. This is intended only to be used with this specific part.

-28mm bass speaker(Saberbay X-Bass speaker recommended)

Please refer to your soundboard's manual for specific wiring diagrams and proper installation of your parts. Wire gauges of 22-24AWG are recommended for all positive and negative connections and 28-32AWG for all other wiring.

Chassis retention is required using one of the M3 screw holes underneath the clamp card area. M3 screw provided with the chassis kit. This is very important to use for proper function of the chassis especially to make sure the switch plungers line up properly.

Available as a standalone chassis option, which includes main body chassis, thin neck adapter part, and low profile emitter PCB emitter.

Also available as a full parts package, with or without a soundboard. Parts packages will include the choice of soundboard(if soundboard included option is selected), and all other install parts mentioned above.

-All 3D printed chassis parts

-Soundboard of choice(if soundboard included option is chosen)

-18650 KeepPower 3000mah high amp battery

-(Two) NPXL V3 un-assembled short pin connectors

-blade side PCB connector

-battery contacts and M3 screw for chassis retention

-OLED screen

-high amp killswitch

-28mm Saberbay X-BASS 4ohm/3W speaker

 

 

Customer Reviews

Based on 10 reviews Write a review