KR Pixelstrip V2 Neopixel Blade 1”
KR Pixelstrip V2 Neopixel Blade 1”
KR Pixelstrip V2 Neopixel Blade 1”
KR Pixelstrip V2 Neopixel Blade 1”
KR Pixelstrip V2 Neopixel Blade 1”
KR Pixelstrip V2 Neopixel Blade 1”
KR Pixelstrip V2 Neopixel Blade 1”
KR Pixelstrip V2 Neopixel Blade 1”
KR Pixelstrip V2 Neopixel Blade 1”

KR Pixelstrip V2 Neopixel Blade 1”

Regular price $145.00 Save $-145.00
/
Shipping calculated at checkout.

PLEASE NOTE, THESE MAY NOT WORK WITH YOUR NEOPIXEL SABER. The blade side PCB connection used on these blades is intended to be used with common hilt side connectors, such as ones made by ShtokCustomWorx, The Custom Saber Shop, CC Sabers and other manufacturers who make their connectors with a single pin in the center for a data line.
Some companies, such as LGT, Saberforge, and any other vendor who uses a hilt side neopixel connector made by Saber Studio that has two pins in the center for a data line, may not line up properly with the blade and not work correctly. This is not an issue with the blade itself but merely a flaw in the design of those hilt side connectors.
Please check before purchasing that the hilt you have does not have a hilt side neopixel connector made by Saber Studio. We can not offer a return or refund for this.

Note that all lit blade product pictures are taken in a well lit room during the day, for example of overall brightness.

1" Neopixel blade made using KR Sabers V2 rigid strips.
These are the only neopixel strips on the market made specifically for neopixel sabers. These blade are intended primarily for show purposes, and are not covered by a dueling warranty or any other misuse of the product.

Please note that is for the blade only, no other parts, electronics or lightsaber is included. Please make sure before purchasing that you have a neopixel compatible saber that can use a 1" sized blade.

Comes in two lengths only, 32.5" and 35.5"
Led count for the 32.5" length is 122 pixels, led count for the 35.5" length is 135 pixels.

You can opt for either a sanded blade finish, or a non sanded glossy blade finish. Neither finish impacts the overall performance or function of the blade. Due to various lightsaber emitter sizes, some sanding of your blade may be required at the base for a snug fit. If your blade does not fit into your blade emitter, you can sand the base using some of the techniques in this video link below.

https://www.youtube.com/watch?v=Xrj7-tSV6bk

Blade is constructed using KR Sabers V2 strips, 1" trans white thin walled diffused blade material, diffusion tube film, diffusion foam, hollow parabolic shine through blade tip, 1" ShtokCustomWorx thin walled blade side PCB holder(Mag-Connect compatible), and ShtokCustomWorx blade side PCB. Resistor is built into the blade so no extra resistor is necessary. All blade wiring uses 22AWG high temp PTFE wire.