1" blade plug Spring Loaded Graflex
1" blade plug Spring Loaded Graflex

Graflex 1" Blade Plug

Regular price $21.50 Save $-21.50
/
Shipping calculated at checkout.

BUYER DISCRETION: This product uses ShtokCustomWorx blade side PCB connectors. 
While the blade side PCB is a fantastic product, it is not compatible with certain LGT/SaberStudio sabers that use their own SaberStudio hilt side neopixel pin connector.
Some of their connectors use two separate pins for the data line, which will not line up with the blade side PCB used on this product. You will either need to upgrade your saber with a compatible connector, such as the NPXL V3, or use it with a saber that utilizes a different neopixel hilt side connector.

1” Graflex blade plug
Center brass piece pushes down and springs back up just like the original Graflex flash bulbsocket does

Make any saber with 1” blade holder looker even cooler on display

No custom heights this are pre built

These are modular and unscrew in the middle
The comes standard 42mm tall
Unscrewing the bottom half makes
It 23mm tall (measuring the blade material not the brass pin. Brass pin extends 7.5mm)

The NeoPixel Version is 45mm tall(due to adding the npxl blade side pcb and Custom pcb holder)

A great piece to make your Graflex light saber accurate

**As with all blades or blade plugs these may require light sanding for desired fit since most blade holders on hilts are not exactly the same, which is done by holding with sand paper and twisting the plug for an even material removal **

Customer Reviews

Based on 62 reviews Write a review