Note that all lit blade product pictures are taken in a well lit room during the day, for example of overall brightness.
7/8" Neopixel blade made using KR Sabers V2 rigid strips.
These are the only neopixel strips on the market made specifically for neopixel sabers. These blade are intended primarily for show purposes, and are not covered by a dueling warranty or any other misuse of the product.
Please note that is for the blade only, no other parts, electronics or lightsaber is included. Please make sure before purchasing that you have a neopixel compatible saber that can use a 7/8" sized blade.
Comes in two lengths only, 32.5" and 35.5" Led count for the 32.5" length is 122 pixels, led count for the 35.5" length is 132 pixels.
You can opt for either a sanded blade finish, or a non sanded glossy blade finish. Neither finish impacts the overall performance or function of the blade. Due to various lightsaber emitter sizes, some sanding of your blade may be required at the base for a snug fit. If your blade does not fit into your blade emitter, you can sand the base using some of the techniques in this video link below.
Blade is constructed using KR Sabers V2 strips, 7/8" trans white diffused blade material, diffusion foam, threaded blade tip, 3D printed custom blade side PCB holder, and SCW blade side PCB. Resistor is built into the blade so no extra resistor is necessary. All blade wiring uses 22AWG high temp PTFE wire.