Chassis design from Jimmy's Saber Junk
This is a removable battery design. 3D printed.
Printed to order, I also include the battery tabs that are required for this chassis design. (Option 1)
This chassis is designed for use with:
-CFX, Proffie Board, GHV3 or Verso
-28mm Bass speaker
-removable 18650 battery
-High amp kill switch
-Shtok NPXL V3 or Eco Short Pin Hilt side LED PCB
FULL INSTALL PARTS KIT includes:
-Proffieboard V3.9
-NPXL ECO shortpin hilt side connector (unassembled)
-removable KeepPower 18650 3000mah 15A battery
-high amp killswitch
-28mm X-BASS 4ohm/3W bass speaker
This design allows for the board to slide into place once wired up and tested.
After wires are soldered to the battery tabs, I suggest carefully heating up the battery tabs to insert them into the chassis. This not only makes it a lot easier to insert them, but also forms the plastic around them, holding them far better.
This is printed to order. Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.
Sign up for email notifications
Subscribe to the mailing list to notifications for new products, upcoming sales and more!