KR Sabers Regiis Chassis for Installs
KR Sabers Regiis Chassis for Installs
KR Sabers Regiis Chassis for Installs
KR Sabers Regiis Chassis for Installs
KR Sabers Regiis Chassis for Installs
KR Sabers Regiis Chassis for Installs
KR Sabers Regiis Chassis for Installs

KR Sabers Regiis Chassis for Installs

Regular price $30.00 Save $-30.00
/
Shipping calculated at checkout.

Install chassis for the KR Sabers Regiis hilt. This listing does not include the hilt, that is purchased separately from KR Sabers. 
Chassis is a single fully removable chassis, 3D printed in black PLA+ filament. 
Chassis inserts through the bottom of the hilt after removing the pommel, and pushes out from the top using your finger. 
In order to insert and remove the chassis, you must unscrew the main red button for the top of the chassis to slide past. Once inserted you can rescrew the button back in, there is no other additional retention screws needed to secure the chassis in place. 

Chassis uses the following parts for install:

-CFX, Proffie, GoldenHarvestV3 or Verso soundboard

-Removable 18650 KeepPower button top battery

-NPXL V3 short pin connector

-SCW tactile switch PCB set

-22mm Veco bass speaker

Install from the top NPXL connector first, then wire the tactile switch PCB's and pass the wires through the channel in the chassis. Wire the speaker and insert into the holder on the bottom, where there should be plenty of room to enclose the speaker and push it in for better resonance. Wire up the negative battery contact and lastly the positive battery contact. Solder all wires to the board last.

 

Chassis packages can be purchased separately or with parts included. Parts packages are as follows:

-Chassis Only: Includes 3D printed chassis, tactile switches and battery contacts(option 3)

-Parts Kit w/o Board: Includes all parts above, plus 18650 KeepPower 3000mah 15A button top battery, NPXL V3 unassembled short pin connector, 22mm Veco speaker

-Parts Kit w/ Board: Includes all parts above plus choice of soundboard