STL FILE KR Sabers Regiis Chassis for Installs CFX
STL FILE KR Sabers Regiis Chassis for Installs CFX
STL FILE KR Sabers Regiis Chassis for Installs CFX
STL FILE KR Sabers Regiis Chassis for Installs CFX
STL FILE KR Sabers Regiis Chassis for Installs CFX
STL FILE KR Sabers Regiis Chassis for Installs CFX
STL FILE KR Sabers Regiis Chassis for Installs CFX

STL FILE KR Sabers Regiis Chassis for Installs CFX

Regular price $25.00 Save $-25.00
/
Shipping calculated at checkout.

This is a digital file download for the STL file of this chassis, this is not a physical product and you are responsible for your own 3D printing. Saberbay is not liable for user printer issues or malfunction of equipment. 

This purchase is for a one time use of this product. This STL file is the intellectual property of Saberbay and not intended for unauthorized resale or distribution of these files. If you need to use the file again for an additional use(outside of needing to reprint due to a chassis break or other error), you will need to purchase the files again to be authorized to use them.

After purchase you will receive a one time digital download for this product, please do not click on the download link until you are able to use it. 
The download will be good for 24 hours after purchase. I will not reissue files for improper downloading or time expiration.

Install chassis for the KR Sabers Regiis hilt. This listing does not include the hilt, that is purchased separately from KR Sabers. 
Chassis is a single fully removable chassis, 3D printed in black PLA+ filament. 
Chassis inserts through the bottom of the hilt after removing the pommel, and pushes out from the top using your finger. 
In order to insert and remove the chassis, you must unscrew the main red button for the top of the chassis to slide past. Once inserted you can rescrew the button back in, there is no other additional retention screws needed to secure the chassis in place. 

Chassis uses the following parts for install:

-CFX, Proffie, GoldenHarvestV3 or Verso soundboard

-Removable 18650 KeepPower button top battery(battery contacts Option 3)

-NPXL V3 short pin connector

-SCW tactile switch PCB set

-22mm Veco bass speaker

Install from the top NPXL connector first, then wire the tactile switch PCB's and pass the wires through the channel in the chassis. Wire the speaker and insert into the holder on the bottom, where there should be plenty of room to enclose the speaker and push it in for better resonance. Wire up the negative battery contact and lastly the positive battery contact. Solder all wires to the board last.