This is a digital file download for the STL file of this chassis, this is not a physical product and you are responsible for your own 3D printing. Saberbay is not liable for user printer issues or malfunction of equipment.
This purchase is for a one time use of this product. This STL file is the intellectual property of Saberbay and not intended for unauthorized resale or distribution of these files. If you need to use the file again for an additional use(outside of needing to reprint due to a chassis break or other error), you will need to purchase the files again to be authorized to use them.
After purchase you will receive a one time digital download for this product, please do not click on the download link until you are able to use it. The download will be good for 24 hours after purchase. I will not reissue files for improper downloading or time expiration.
When installing this chassis, it is recommended you install the speaker, battery contacts, and tactile switch first, then wire your preferred NPXL connector and holder into place in the emitter, and then pass the wires through the wire channel passage in the top part of the chassis. The chassis will need to be partially pressed into the emitter and your soundboard gets wired up last. After wiring you can secure your board in place with a press fit or use the cutout for a thin piece of crafting tape. Afterwards, fully insert the chassis into the hilt, it will be a snug fit and should line up with the switch actuator.