This is an STL file for the chassis design specific for the listed saber in the description. Not intended for use for any other saber. After purchase, you will be sent an email with a ZIP file containing all required files for this chassis design. Please download the ZIP file to your desktop for proper use. This purchase is for a single use of this design on your personal saber, and unauthorized reuse or distribution of these files are strictly prohibited and will result in a permanent ban of your account and/or future purchases with Saberbay.
Chassis design from Jimmy's Saber Junk
This is a removable battery design. Printed in black PLA+ filament Printed to order, I also include the battery tabs that are required for this chassis design. (Option 1) This chassis is designed for use with: -Proffie Board, GHV3 or Verso (board not included) -28mm Bass speaker (not included) -18650 Lithium Ion Battery (not included) -High amp kill switch (not included) -Shtok NPXL V3 or Eco Short Pin Hilt side LED PCB (not included-most likely requires sanding down on the outside diameter)
This design allows for the board to slide into place once wired up and tested. After wires are soldered to the battery tabs, I suggest carefully heating up the battery tabs to insert them into the chassis. This not only makes it a lot easier to insert them, but also forms the plastic around them, holding them far better.
This is printed to order using PLA plastic. Handle with care. Any damage occurred during installation is the responsibility of the individual installer.