Master Sentinel V2 Basic Install Chassis
Master Sentinel V2 Basic Install Chassis

Master Sentinel V2 Basic Install Chassis

Regular price$255.00
Shipping calculated at checkout.

Full Parts Kit

3D printed basic install chassis for the Master Sentinel V2
Please note that this is designed only for the V2 and not intentionally compatible with any other saber design.

This is a fully removable chassis design for holding all of the electronics required for a basic installation, accessible through the pommel of the hilt.
The chassis aligns with an internally protruding set screw inside the hilt for proper switch alignment with the actuators.
There are optional spots for a basic crystal chamber illumination, designed around the resin printed crystals sold here in the store, as well as two locations for single pixel accent LED's for the shine through bezels on the hilt.

Parts list for installation:
-CFX, Proffie or GHV3 soundboard
-NPXL shortpin hiltside connector or similar
-qty.2 brass tactile switches 1.5mm height (included with chassis)
-removable 18650 button top protected cell (Option 2 contacts included with chassis)
-qty.2 single pixel accent LED's for sides(optional)
-single pixel accent LED for crystal chamber illumination (optional)
-high amp killswitch
-28mm bass speaker

-choice of soundboard 
-NPXL V3 shortpin assembled connector
-qty.3 single pixel accent LED's
-resin printed crystal
-high amp killswitch
-removable KeepPower 18650 3000mah 15A protected cell
-28mm X-BASS 4ohm/3W bass speaker

You may also like