Blade Side Connectors

Blade side PCB's for making neopixel blades, blade plugs, and other neopixel connections.

Use with our thin or thick walled blade side holders(1" or 7/8" compatible)

WITH LEDS version are perfect for making easy neopixel blade plugs with the correctly sized holder. No extra wires necessary for blade plug function.

Explanation here --> https://youtu.be/Fpv4AnaMPoY
-Each set includes 0603 470 ohm resistor required for data line(foot prints on both blade and hilt side connectors)
-Resistor already placed on V2 With LED

V2 with led means quick and easy neo pixel blade plug

Specifications:
- true 20A max current rating
- 17.5mm pcbs OD
- Gold Plated wear out resistive finish
- 0603 Data resistor footprint on “Blade” pcb
- big solder pads for easier wiring
-V2 includes "blade id" resistor foot print(optional)

*Last two pictures for comparison to older version*

Blade side PCB's for making neopixel blades, blade plugs, and other neopixel connections.

Watch this video for a tutorial on soldering the resistor yourself: Watch here

Updated with wider data line radius for more universal compatibility. Soldering pads include two positive and negative labeled pads, and single data pad across from SMD resistor footprint. 
All PCB’s will include 0603 330ohm resistor for data line.

Specifications:
- true 20A max current rating
- 17.5mm pcbs OD
- Gold Plated wear out resistive finish
- 0603 Data resistor footprint on “Blade” pcb
- big solder pads for easier wiring

*****PCB SOLD SEPERATELY*****

This is the blade side PCB holder for 7/8″ thin walled blades designed for ShtokCustomWorx NPXL purchase here https://tinyurl.com/npxlbladeside .

Machined from clear acrylic. It is not compatible with any third party PCB. It can also be used for the blade side PCB with LEDs to make a quick NeoPixel blade plug!
The PCB is press fit but it can be further secured using a small dab of hot glue or similar glue.

*****DOES NOT INCLUDE PCB*****
This is for the blade side and for 1″ thin walled blades.
Machined from clear acrylic. It is not compatible with any third party PCB. Designed for this product sold here https://tinyurl.com/npxlbladeside

It can also be used for the blade side PCB with LEDs to make a quick NeoPixel blade plug
This is MagConnect compatible. Magnets are sold separately here https://tinyurl.com/magconnectors.
Be aware the magnets are a snug interference fit.
They will still need be glued in so the force of the magnets does not pull them out when near each other.
We recommend a low viscosity CA glue for this.
Be careful when doing this; the magnets are fragile. Also, it is important to note that due to the tolerances, be sure to check the fitting of the holder inside the emitter before the magnets have been put it and after. The addition of the magnets may expand the holder slightly resulting in a tighter fit. If this is the case, we recommend lightly sanding the outside of the magnets using a sanding drum to reduce the outer diameter slightly. This will stop the holder from expanding after installing the magnets.
Note that the PCB is press fit but it can be further secured using a small dab of hot glue or equivalent.

3D printed in black PLA+ filament. 
Budget friendly holders for ShtokCustomWorx blade side PCB's.

Can be used for regular and LED versions. Available in thin and thick walled options. 

Lightly sand the outside of your blade side PCB for a press fit, they will require sanding to ensure proper fitment without the use of glue. 
These do not include the cutout for the Mag Connect magnets.