Two piece pogo speaker connector set from ShtokCustomWorx This is the V2 version which is used for tighter space builds. You will need to remove the excess material around the flat PCB as well as carefully cut the two pogo pins down the middle. Flat PCB needs to be secured to the back of your 28mm speaker as shown in the picture. This is only intended for 28mm bass speakers.
These are small profile PCB's designed for chassis designs which require tactile switches without the need to solder directly to the switch. These also come in a neopixel accent LED version, with built in pixel accents.
Product dimensions are 11mmx6mmx3mm. Height is including the height of the tactile switch. Actual PCB material height is 1mm.
PCB has solder pads for both switch wires, one for actual switch to return to the switch pad on the soundboard, and the other for the ground, orientation does not matter.
PCB's also have solder pads for the pixel accents, labeled with a + or - sign, as well as a Di(Data In) and Do(Data Out), for wiring your data line.
Please refer to your soundboards manual for proper wiring diagrams for the wires to return to your soundboard.
Pixel accent LED versions are preresistored for the data line.
Small wire gauges of 30-32AWG are required for proper wiring installation.
RGB "Neo-TriLED" (NeoCree) Module made from collaboration between WarSabers and ShtokCustomWorx
This is an adapter to go from neopixel to RGB tricree LED. No other wiring or configuration changes required.
Module is a for 1" sized emitters only and is approximately 20mm in total height. Please make sure you have adequate emitter depth to use before ordering.
Color of the LED will make your color configurations of your neopixel setup.
If you are using this product with an LGT hilt side connector, it may not work without some slight modification of the pins in your hilt. If you have a connector that uses two off center pins in the middle for a data line, you will need to slightly bend them together.
3D printed in black PLA+ filament. Budget friendly holders for ShtokCustomWorx blade side PCB's.
Can be used for regular and LED versions. Available in thin and thick walled options.
Lightly sand the outside of your blade side PCB for a press fit, they will require sanding to ensure proper fitment without the use of glue. These do not include the cutout for the Mag Connect magnets.
*Last two pictures for comparison to older version*
Blade side PCB's for making neopixel blades, blade plugs, and other neopixel connections.
Updated with wider data line radius for more universal compatibility. Soldering pads include two positive and negative labeled pads, and single data pad across from SMD resistor footprint. All PCB’s will include 0603 330ohm resistor for data line.
Specifications: - true 20A max current rating - 17.5mm pcbs OD - Gold Plated wear out resistive finish - 0603 Data resistor footprint on “Blade” pcb - big solder pads for easier wiring
NPXL V3 hilt side neopixel connector without the LED's. These are the same exact size and basic function as the regular V3 connectors, with soldering pads for the neopixel positive and negative connections, as well as the data line and blade detection pads. These DO NOT have a spot for an SMD 0603 resistor, as most resistors will be built into the blade or on the soundboard now.
Available as PCB only, short pin and long pin, assembled or non assembled versions.
The assembled versions will have the pins pre soldered, and the non assembled versions will include the selected pin type separately to solder yourself. The PCB only version will not include any pins.
Pin guide alignment tool for soldering the NPXL V3 longpin connector. This is a basic PCB board material. Not compatible with other designs. Easily slides over your pins before soldering to ensure they are straight and in proper alignment.
NPXL V3 connector not included with this purchase.