3D printed crystal chamber install chassis designed specifically for the newest version of the Creepy Uncle from Denis Lukyanov (2024 release).
Please note this design will not be compatible with any other hilt or version of this hilt.
Printed in separate parts, includes two main items and small parts for the inner grenade section, emitter section, and control box.
Pictures shown with additional electronics are for demo purposes only, this listing does not come fully installed and you are required to do your own installation or source a third party installer.
This design requires a ProffieV3.9 for easy USB port access, either through a standard USB-C port or a ShtokCustomWorx USB port.
Only compatible with the non helper board control box setup, for killswitch control box access.
Parts list required for install:
-ProffieV3.9 soundboard
-qty.1 NPXL shortpin hiltside connector (or similar)
-qty.1 thin neck PCB set
-Power/Speaker PCB connector set (LARGER standard size, NOT the 17.5mm version)
-high amp killswitch (optional)
-USB C port or ShtokCustomWorx USB port
-removable 18650 protected button top battery(Option 2 battery contacts included with chassis)
-28mm bass speaker
-single pixel accent LED for crystal chamber
-qty.2 6x3x4.3mm tactile switch (included with chassis)
-red and green 3mm accent LED's (included with chassis, optional for install)
-68ohm resistor for red accent LED (included with chassis)
-4mm brass tube for wire channel passageway(optional and not required)
Sign up for email notifications
Subscribe to the mailing list to notifications for new products, upcoming sales and more!
