Dual brass tactile switch holder for 12mm switch holes. The outer diameter of these are 14mm, with the smaller section 12mm.
Due to switch hole variances of different hilt manufacturers, you may need to sand the outside of these to fit snugly or sand the inside of the switch hole.
Comes in either aluminum, black anodized, copper or brass finish. The back retainer piece is only made in aluminum. This listing will include one complete kit to make the assembly.
-1 aluminum, black anodized or brass switch holder
-1 aluminum back retainer
-2 brass tactile switches (5mm height)
-2 set screws (M2x3mm)
Please refer to pictures for proper installation and trimming of tactile switch legs.