Install chassis for the One Replicas Super Stunt Obi Wan (TPM version) hilt only. Chassis is not compatible with other hilts.
3D printed in two parts in black PLA + filament.
This is a DIY chassis, you will need to install your own electronics into the chassis.
Chassis parts required listed below
-Soundboard of either CFX, Proffie, or GoldenHarvestV3
Top part of chassis is inserted from the top, held in place by brass greeblie screw
-NPXL V3 short pin connector(or similar size)
-single red momentary tactile switch(see pictures for example, switch is included with the chassis)
-ShtokCustomWorx Rotary Chassis PCB set(flat PCB side)
Bottom half of the chassis is fully removable and holds the following:
-Choice of soundboard
-removable 18650 button top battery(battery contacts provided with the chassis)
-ShtokCustomWorx Rotary Chassis PCB set(pin side PCB)
-high amp killswitch(optional)
-22mm speaker(speaker will need to pressed in all the down, see pictures for example)
Chassis can be purchased as a chassis parts only purchase and will include both chassis parts, tactile switch, and battery contacts. You will then need to acquire your own parts for install.