Universal 1” or 1.1” Removable Install Chassis
Universal 1” or 1.1” Removable Install Chassis
Universal 1” or 1.1” Removable Install Chassis
Universal 1” or 1.1” Removable Install Chassis
Universal 1” or 1.1” Removable Install Chassis
Universal 1” or 1.1” Removable Install Chassis
Universal 1” or 1.1” Removable Install Chassis

Universal 1” or 1.1” Removable Install Chassis

Regular price $20.00 Save $-20.00
/
Shipping calculated at checkout.

Fully removable install chassis designed for hilts with at least a 1" inner diameter, or 1.1" inner diameter for the grip section. 

This is a DIY kit. All assembly and installation is the responsibility of the end user. Please refer to your soundboard's manual for proper wiring diagrams and applications. 

For pre-installed options, please contact the store, but this is NOT a fully installed product. 

Please read all instructions and details about this product below before purchasing. These chassis products are made to order and not eligible for returns or replacements due to wrong products or sizes being ordered that may or may not fit your saber hilt.

Hilt requirements:

At least a 1" inner diameter all the way through. Thin neck sabers or sabers that narrow to a less than 1" inner diameter will not work. 
Your hilt must also be able to use some kind of switch plunger or actuator to press down onto the tactile switch PCB's built into the chassis. There are several switch plunger or actuator options here on the page, or you can use your own or another third party. Also requires a retention screw somewhere in the general vicinity above the switch area. This is used for chassis retention and proper alignment. Most hilts will have one for the heatsink or neopixel holder but if you do not have one, you can always drill and tap your own.

PRODUCT DESCRIPTION AND PARTS INCLUDED:

Total chassis length is 7 5/16" in length. Please ensure you have adequate space for the chassis in your hilt. This length does not include the speaker. 

1" chassis version is 1" in outer diameter all the way throughout the chassis. 
1.1" chassis version is 1.1" in the speaker area only, the rest of the chassis is 1".

Empty Chassis Kit Only will include the 3D printed chassis part in black PLA+ filament, battery contacts, and a set of two SCW Tactile Switch PCB's. Please make sure to choose the soundboard option required for the install. (CFX, Proffie, GoldenHarvestV3).

DIY Parts Kit w/o Soundboard will include the empty chassis, battery contacts, SCW Tactile Switch PCB's, KeepPower 18650 3000mah 15A battery, NPXL V3 unassembled short pin connector, and proper speaker based on the size of the chassis option. 
1.1" chassis will include a KR Sabers 28mm 4ohm/3W bass speaker, and 1" chassis will include a Veco 22mm 4ohm/3W bass speaker.

DIY Parts Kit w/ Soundboard will include all parts listed above in addition to the soundboard required for install. 
All boards will include SD cards, CFX and Proffie boards will need to be programmed, GoldenHarvestV3 boards will come preprogrammed for neopixel.