Sale starts 11/19 and runs through the end of day 11/30
10% off storewide on all products!
Double rewards points for Loyalty Rewards program
Use discount code 'BF2026' at checkout!
*BF2026 discount code can not be combined with any other discount codes at checkout*
Fully removable install chassis designed for hilts with at least a 1" inner diameter, or 1.1" inner diameter for the grip section.
This is a DIY kit. All assembly and installation is the responsibility of the end user. Please refer to your soundboard's manual for proper wiring diagrams and applications.
Please read all instructions and details about this product below before purchasing. These chassis products are made to order and not eligible for returns or replacements due to wrong products or sizes being ordered that may or may not fit your saber hilt.
Hilt requirements:
At least a 1" inner diameter all the way through. Thin neck sabers or sabers that narrow to a less than 1" inner diameter will not work.
Your hilt must also be able to use some kind of switch plunger or actuator to press down onto the tactile switch PCB's built into the chassis. There are several switch plunger or actuator options here on the page, or you can use your own or another third party. Also requires a retention screw somewhere in the general vicinity above the switch area. This is used for chassis retention and proper alignment. Most hilts will have one for the heatsink or neopixel holder but if you do not have one, you can always drill and tap your own.
PRODUCT DESCRIPTION AND PARTS INCLUDED:
Total chassis length is 7 5/16" in length. Please ensure you have adequate space for the chassis in your hilt. This length does not include the speaker.
1" chassis version is 1" in outer diameter all the way throughout the chassis.
1.1" chassis version is 1.1" in the speaker area only, the rest of the chassis is 1"
Parts list for install:
-CFX, Proffie, GHV4
-up to two Tactile Switch PCB's (two are included with chassis print)
-NPXL shortpin hilt side connector
-removable 18650 button top protected cell
-28mm bass speaker for 1.1" chassis options, 22mm speaker for 1" chassis options
Unfortunately these prints can't survive a weekend in a car during the summer. The chassis got hot and warped sagging to one side and became brittle. I'm going to have to purchase another one as my build kinda centers around this..
As a friendly PSA to customers, please do not leave anything 3D printed in a hot car in the summer over the weekend 🙃
Sign up for email notifications
Subscribe to the mailing list to notifications for new products, upcoming sales and more!
Premium components, blades, and electronics for your next build