Clone Wars Petro

Designed and produced by Saberbay, this is Petro’s hilt based off the character from the Clone Wars series.
Available as an empty hilt only for this listing 

Hilt kit is broken down into multiple parts and will arrive mostly assembled for you. See listing pictures for example of all parts.
Hilt takes a 1” blade in the emitter
Grips can be added on with or without a grip guide(sold separately).
Grip pieces will come with strong double sided adhesive to apply to hilt control box and grip section.

Install chassis for the Saberbay Petro hilt
Available as empty chassis printed in two parts.

Empty chassis will include both chassis parts and battery contacts. Top half of chassis is held in place by larger set screw in the control box.
It is recommended to install your V3 connector first, with enough wire leads to extend a few inches out the bottom, then wire the switches in place in the control box and pass the wires through the openings. Wire the chassis PCB last and press fit into the bottom.
Bottom half of chassis holds the soundboard, battery, other chassis PCB(pins go on this side), and 28mm bass speaker.

Parts list for chassis install:
-3D printed chassis parts and battery contacts
-SCW rotary chassis PCB kit w/ pins
-KeepPower 18650 3000mah 15A battery
-Saberbay X-BASS 28mm 4ohm/3W speaker
-V3 Long pin connector(Unassembled)
-V3 ‘old style’ lens cover

3D printed grip guide for our Petro hilt. Easily slides over grip section of the hilt to help evenly space out the 4 grips that come with the hilt.
The guide will stop itself in the correct spot to also space out the grips to be centered on the grip section.