Crimson Lord 2ND GEN. Chassis for Installs Crystal Chamber Version
Regular price $55.00 Save $-55.00Install design for the 2nd Gen, Crimson Lord, designed by Denis Lukyanov.
Chassis design by Jimmy's Saber Junk
3D printed in black PLA + filament, you can paint your chassis to match the pictures or any other preferred color for the main body or crystal chamber. You will need your own crystals for this chassis. Chassis is printed in 3 main parts.
Please note this is for the 2ND Gen. Crimson Lord only, not compatible with any other hilts.
Crimson Lord 1ST GEN. Chassis for Installs
Regular price $50.00 Save $-50.00Install design for the 1st Gen, Crimson Lord.
Chassis design by Jimmy's Saber Junk
3D printed in black PLA + filament, you can paint your chassis to match the pictures or any other preferred color for the main body or crystal chamber.
Please note this is for the 1st Gen. Crimson Lord only, not compatible with any other hilts.
Crimson Lord Dual CFX Installed *Made to Order*
Regular price $1,100.00 Save $-1,100.00Fully installed Crimson Lord with dual CFX boards
Please read all information and details before purchasing
Fully installed with two CFX soundboards. Chassis is fully removable using Jimmy Saber Junk’s chassis design 3D printed in black PLA+. The chassis is inserted from the non claw emitter end by unscrewing the emitter fully and pushing the chassis in all the way, the chassis will align with the switches and the switch actuators on the hilt. To remove the chassis, perform this step in reverse and push the top of the chassis from the clawed end, gently using your hand/finger until you can comfortable grab the other end and pull it out.
Full parts details below: this install features two matching installs to independently control each end of the staff
-CFX soundboard, Neopixel with newest firmware
-NPXL V3 Shortpin hilt side connector
-two button configuration
-removable 18650 KeepPower protected battery, 15A 3000mah
-high amp killswitch
-22mm Veco 4ohm/3W speaker
This hilt will come fully assembled with the claws attached. This listing does not include any other parts not described in this listing description
Crimson Lord 2ND GEN. Chassis for Installs
Regular price $50.00 Save $-50.00Install design for the 2nd Gen, Crimson Lord, designed by Denis Lukyanov.
Chassis design by Jimmy's Saber Junk
3D printed in black PLA+ filament. Chassis is printed in 3 main parts.
Please note this is for the 2ND Gen. Crimson Lord only, not compatible with any other hilts.