'Chosen Victor' Install Chassis

Basic install chassis for the Chosen Victor hilt. sold here at Saberbay.
Designed by Jimmy's Saber Junk; this chassis is not compatible with any other hilt.
Printed in 4 separate pieces; 1 for the main body, 2 for the static holder in the emitter section of the hilt, and an additional 2 small pieces used for the tactile switch holder sections(using both of these is optional, however at least one is required for a single switch operation)

Example of similar chassis used for the hilt here

The main body is a removable build, accessed by removing the pommel and sliding out the bottom of the hilt.
Parts list for the install:
-CFX, Proffie, GHV3, or Verso soundboard
-NPXL shortpin hiltside connector (V3 or ECO compatible)
-6 Trace Rotary Chassis PCB set
-two 1.5mm brass tactile switches (included with chassis)
-removable 18650 battery (spring loaded battery contacts included with chassis)
-high amp killswitch (optional, recommended)
-optional OLED screen add on (TCSS, KR or Saberbay version compatible)
-optional Bluetooth BT909 Breakout board add on
-28mm bass speaker 

FULL PARTS KIT includes:
-choice of soundboard (CFX, ProffieV3.9, GHV3)
-qty. 1 assembled NPXL V3 shortpin hiltside connector
-qty. 1 unassembled 6 Trace Rotary Chassis PCB set
-qty.1 KeepPower 18650 3000mah 15A button top protected cell
-qty. 1 high amp killswitch
-qty.1 blue TCSS OLED screen (for OLED chassis options)
-qty. 1 Bluetooth BT909 Breakout board module (for Bluetooth chassis options)
-qty.1 28mm X-BASS 4ohm/3W bass speaker