RTS Sabers

Pre-assembled sabers using our fully installed PixelCores!
Choose between 4 different hilts:
-E08
-E021
-Bullet
-Talon

Choose your PixelCore!
-Proffie core
-GHV3

Add an ECO pixel blade (36" lengths only)

All sabers will come with the PixelCore installed in your hilt. Each core has a two button setup using the Dual Tactile Switch housing. 
Will also include your charging cable for external USB charging, or you can remove the chassis to access the soundboard and removable battery.

Chassis retention now features a longer screw that allows the switch housing to sit flush with the outside of the hilt. You must fully this screw (located behind the switch hole), to remove the chassis from the hilt.

The SK1 from our vendor TXQ. Based on Galen Marek's first saber from The Force Unleashed.
Each saber includes the saber, custom saber stand, instruction manual, charging cable, and allen wrench and retention screws.

Saber can accommodate 1" blades, and a removable chassis system that is easy to use.
Neopixel connectors will have built in blade matching LED's, as well as an exposed illuminated blade matching crystal chamber.
Emitter section also features two shine through accents that illuminate with the blade color.
All installed sabers are equipped with two button function in the control box, and the removable chassis with access to the soundboard, and removable battery. 
USB charging is also possible for the chassis, and batteries included are KeepPower 18650 protected cells.

This listing does not include a blade(purchased separately)

Fully Installed Intromnia hilt with custom weathering. This features a 3D printed control box with clamp card to replace the red trigger.

Please read all details and information in the listing before purchasing

This is a fully installed saber with CFX. The chassis is removable when unscrewing the pommel area as shown, it stays affixed in this section. Please do not try to remove the chassis from this part of the hilt(the pommel).

When reinserting the chassis you will need to mind the alignment of the tactile switches with the hilt switch actuators. You can adjust the clocking of the chassis alignment by alternating the brass piece’s alignment with the pommel, using the fins as a visual guide.

Full parts details below:

-CFX soundboard, Neopixel with newest firmware

-NPXL V3 Shortpin hiltside connector 

-two button configuration using SCW Tactile Switch PCB’s, with blade matching pixel accent LED’s (top for main, bottom for auxiliary)

-high amp killswitch

-removable 21700 KeepPower protected battery, 15A 5000mah, with custom battery wrap

-28mm X-BASS 4ohm/3W speaker

-crystal chamber illumination with independently wired pixel accent LED(can be programmed by end user’s own configuration)

This listing is for the installed saber only, there are no other parts included that are not mentioned in this listing description