This is intended as an intermediate/advanced level install. Not recommended for first timers or beginners.
Basic install chassis for the 89Sabers Count Dooku V3 hilt. Please note that this chassis is not intended for other versions or models of this saber. Make sure you are ordering the correct chassis before purchasing.
3D printed and designed by Jimmy's Saber Junk.
Comes in 8 different parts.
Top to bottom:
-Emitter piece holds the neopixel connector and has a slot to pass the wires for the gold trigger
-6 trace rotary chassis PCB holder (pin side), used for separated the hilt after install
-battery holder (comes with battery contacts, however not intended as a removable battery option), holds high amp killswitch, flat side of 6-trace rotary chassis PCB, and two tactile switches
-two printed plungers; these are glued into the brass actuators included with the hilt, dropped into place inside the correct part of the saber, and aligned in place with the tactile switches
-board holder (Proffie only)
-speaker pod upper section, holds 1.3mm RCP and pins for SPKR PCB
-speaker pod, holds flat part for SPKR PCB set and 22mm speaker
Parts list for install:
-Proffieboard
-NPXL shortpin hiltside connector
-6 trace rotary chassis PCB (required for separating the hilt)
-static 18650 battery (battery contacts included, can also use a prewired battery)
-high amp killswitch
-two 1.5mm brass tactile switches
-1.3mm RCP
-SPKR Type 1 PCB set
-22mm speaker
FULL PARTS KIT includes:
-Proffieboard V3.9
-assembled NPXL V3 shortpin hiltside connector
-6 trace rotary chassis PCB set (unassembled)
-high amp killswitch
-removable KeepPower 18650 3000mah 15A battery
-SPKR Type 1 PCB set
-1.3mm RCP
-22mm Veco 4ohm/3W bass speaker
