Straight Talker Crystal Chamber Install Chassis
Crystal chamber install chassis for the Straight Talker Yaddle hilt. This chassis is 3D printed and does not include any parts not listed with this chassis. Designed by Jimmy's Saber Junk. Printed in three separate parts, use E6000 during installation to secure chassis parts together.
This is a fully removable chassis that is used in conjunction with the Straight Talker's pommel part, which has a small retention screw built in. This is for proper alignment of your switch after installation with the switch plunger in the hilt.
For board retention, you will need E6000 or another viable adhesive to keep the board in place.
Parts list required for install:
-Proffie or GHV3
-NPXL shortpin hiltside connector (V3 or ECO compatible)
-single 1.5mm brass tactile switch (included with the chassis print)
-removable 18350 battery
-high amp killswitch (optional but recommended)
-22mm Veco speaker
-single pixel accent for crystal chamber illumination
FULL PARTS KIT includes:
-choice of soundboard (ProffieV3.9, GHV3)
-qty. 1 assembled NPXL V3 shortpin hiltside connector
-qty. 1 single pixel accent LED
-qty.1 KeepPower 18350 1200mah 10A button top protected cell
-qty. 1 high amp killswitch
-qty.1 22mm Veco 4ohm/3W bass speaker